T-slot V-slot Universal camera mount -- m3 bolts -- remixed

thingiverse

This is a remix in spirit only, all models are remade from scratch but built on M3 screw mounts/holes. I also added a swivel to the top cap of the arm. To attach it, drop a nut into the channel and tighten the screw in from the arm slot. When printing, only do support from the built plate. **PI_CAM_HOLDER** ------------------------------- Just an FYI, I detest supports. I rebuilt the holder into 3 parts, print all 3, put your cam in the front plate (one with the hole for the lens), cut the spacer to fit, it will butt up against the ribbon connector with the 3 block points facing the cam circuit board. Finally, place your top cap on and screw in with two M3 screws (between 6 and 10mm length). Depending on the Pi Cam board, you may need to increase the Z size from 4.5mm to 5mm during print of the inner spacer, as two of my Picams have different thicknesses.