T Scale Turntable Complete

thingiverse

This working turntable prints in 2 pieces: the bridge and the pit.Portions of the model walls were thickened in order to scale down to T Scale. Parts from the bridge and the deck were also combined into a single model. There is a guide way between the bridge and the deck that will allow standard T Scale flex track to be slid in, but the outer ends of the ties will have to be trimmed. Shaft diameter is 5mm. You can run wiring to the track if you use a hollow shaft. Cut the ties where the wires will attach before inserting the track.Print the bridge first full size, Then scale the pit down to the exact diameter that you need for a perfect match. This allows for variations in the resin shrinkage, etc.At this scale )1:450 - 1:480) you need to use a resin printer for good results. As shown below in the remix section, this is remixed from Sumner's N Scale turntable build - links below.