T handle for 5mm hex wrench

prusaprinters

<p>I've got a 4mm hex wrench that came with something that we bought, and I just like the shape of the handle and use it often. I was thinking that the same handle for a 5mm wrench could be quite handy, so I took measurements from the T handle and a 5mm “L” hex wrench and replicated it. This will fit a 5mm “L” hex key with up to a 33mm short end, measured from the outside.</p><p>To print, add a pause in your slicer just before the pocket for the wrench is enclosed. The extra bit will hold the hex wrench level, and once the print is complete, you can cut that off. Print with several shells for sufficient strength. If you want the handle to be nicely balanced, I've used a modifier part in PrusaSlicer to make the side opposite to the L wrench print at 100% infill. &nbsp;It's not necessary, but makes the finished wrench feel nicer.</p>