T-800 Single and 3 Piece High Detail Head

cults3d

Updated Fixed the jaw sitting flat on the plate (if it's not flat still for you, use the lay flat feature - in Makerware it's flat on layer 0.1) and added the full 38mb hi-res skull as requested. I made the pipes fatter! I was tired of them being too weak when printed small, so I increased the thickness of all the pipes by 2mm. This is a remix of my other smoothed T-800, which was remixed from ToScH's one, but I went further this time. I made it even higher res with more detail (literally sculpted out pieces) and split it into three pieces to print specifically with little supports and fix areas where a full print can fail, like the mouth/jaw pipes. Now you can print them the other way around. I also cut the slices so they wouldn't interfere with facial geometry. I removed all the supports under the chin so it's as is now - you could print it upside down or normally, up to you. I cut out the back of the cranium so you can put LED lights in easily to the eyes. If the like button gets clicked enough, I might even cut out the eyes and make them all separate and add the CPU core screw cap. Remix from ToScH & Landru