Syrup Doser V2

prusaprinters

<p>This is not a crack pipe but a doser to aromatise sparkling water with syrup. It is designed for syrup bottles with PCO-1881 thread. Fully filled this doser dispenses an amount of 20 ml syrup sufficient for the content of a standard bottle for sparkling water makers of 860 ml.</p><p>It needs a bit exercise to use it but then it is easy to dose the syrup. The second picture shows how to fill the doser with syrup, the third picture the pouring out.</p><p>Edit 2016/12/21: New design V2. This design prevents the backflow of syrup out of the doser into the syrup bottle when pouring out.</p><h3>Print Settings</h3><p><strong>Printer:</strong></p><p>FIashForge Dreamer</p><p><strong>Rafts:&nbsp;</strong></p><p>No</p><p><strong>Supports:</strong></p><p>Yes</p><p><strong>Resolution:&nbsp;</strong></p><p>0.20 mm</p><p><strong>Infill:</strong></p><p>100%</p><p><br>&nbsp;</p><p><strong>Notes:</strong></p><p>&nbsp;</p><p>Print it with transparent PETG because it is food safe and you can watch the fill level.</p><p>Support is only needed underneath the tubes. All other areas can be printed without support if a filament cooling fan for the nozzle is used.</p><h3>Post-Printing</h3><p>It is recommended to print the also attached seal and cap with TPE to prevent a mess and to be able to close the doser after use.</p><h3>&nbsp;</h3><p>Category: Kitchen &amp; Dining</p>