syma x5c,x5sw,x5se drone body

thingiverse

This body is specifically designed for Syma drones like x5sw and x5se. The printer settings are as follows: nozzle temperature, 220 degrees; bed temperature, 50 degrees. No supports are required for this print. Infill should be between 15-20%. Parameter 1 is set. The layer height is 0.3 millimeters. Resolution can range from 0.2 to 0.4 millimeters. On the four mini squares holding the Syma receiver board, there are holes that keep it in place. Due to resolution differences, these holes might not be perfectly made. You can adjust the hole diameter according to your screw needs.