Sy's Peglock - Divided Bin

prusaprinters

This bin should fit most small tools, brushes, files, picks, tweezers, or whatever else you care to throw in it. A divider runs most of the way up, dividing the bin in half to prevent tools from tipping too far over. The entire container bends slightly outward to make adding and removing items easier.This model uses my locking pegboard mount system for 1" standard pegboards. Magnet holes (if present) are designed for 10mm diameter, 3mm thick magnets. “Board Attachment” parts are universal to all models. Print with 3 perimeters and 0.3mm or thinner layer height for best results.To mount, fold the "Board Attachment" model, insert it into the pegboard so the triangular surface points up, then slide the mount over top. With a bit of force it should fully lock into place. If needed, use a small mallet or similar to mount/remove.