Sword and Shield Gym Leader Ball Holder

pinshape

I created this ball holder to complement my Sword and Shield cosplay. First, I designed it to be compatible with the Clip N' Go system, which can be purchased at https://amzn.to/37jhnUj. Next, I decided to craft individual balls as solid models and hollow ones that could be assembled by gluing them together then secured. In total, there are three different back plates. Two of these wrap over the side of one's pants. The other features a hole at the top for attaching it to a belt. Due to the weight, it is recommended to secure these back plates to a belt under one's shorts in general. There are two front pieces that hold the balls. One of these pieces has sections where balls can be snapped into place. The other front piece has holes where a screw can be used to attach the ball to the front plate. Both the front and back plates are connected with a 1/4 inch (6.35 mm) in diameter screw post. The entire model, when assembled, measures approximately 203 mm x 139 mm x 82 mm.