Switchbox V5 - Hinged

thingiverse

*Update 2019/04/08: Check out my new version that holds 4 controllers! https://www.thingiverse.com/thing:3550691\r\n\r\n*Update 2017/12/12: Files for large printer beds (250mm or greater) with the base and lids fused have been added*\r\n\r\nAfter using my V4 Switchbox for a while, I decided to give the sliding mechanism a serious overhaul. This design is essentially the same on the outside, but now has a hinged lid that allows easy access to the Switch from the top. It's much more secure - less likely to drop your Switch or game cartridges. A built-in slot also lets you stand up the screen during play.\r\n\r\nThe clasp has been revised since the photos here. Check out the rendered versions for the new look.\r\n\r\nThis version prints on a 200x200mm bed. You'll need:\r\n- M3 screws, 5mm x 10 for assembly\r\n- M3 screws, 20mm x 2 for the hinges\r\n- glue, CA or other types - I use contact cement. Gluing the shell halves together is recommended, rather than relying just on the screws.\r\n- thin foam sheets from any craft store to make the cushions.