Switch for hand warmer (ihatethecold.com)

prusaprinters

This is a replacement switch for the pictured hand warmer from "ihatethecold.com". The original fell off and got lost. This one will need to be attached with a small amount of glue. Be careful to only use a small amount and only where you need it. I used a "gel" type super glue. You could also probably use a small amount of two part epoxy.Print SettingsPrinter Brand:Anycubic Printer: All-metal MegaRafts: Doesn't Matter Supports: Doesn't MatterResolution: 0.1 Infill: Doesn't MatterFilament:CC3D PETG Black  Notes: I recommend printing this in a heat resistant material.... because it's a hand warmer. I used PETG. I'm sure ABS would also work. If this design was useful to you, please post a make!