Swiss Arca and Pic Rail for FX Impact

prusaprinters

This part replaces the trigger guard on the FX Impact.  It allows the air gun to be used with an Arca Swiss tripod and extends the area available for a pic mounted bipod.  I uses the bottle to increase the stiffness and more or less eliminate deflection.  It is a contact fit to the bottle, so it is easy to remove and install.I printed this out of BASF HTPA-CF15.  Given the use conditions and the possible stresses, I would recommend something with low moisture sensitivity, good heat resistance and high stiffness like this material.It is designed to print diagonally off the front face for 2 reasons.  The support required is minimal, and it keeps the primary forces from falling along the layer interface.