Swing Arm Tie Rack 3D print model

cgtrader

This tie holder is an effortless and practical print perfect for OCD individuals who value orderliness. However, before installing it, please review the comprehensive list below. Ensure the anchor brackets are either screwed into a stud or use drywall anchors to prevent the rack from falling off the wall. Additionally, tighten until snug but avoid overtightening, which can cause bracket cracks. Infill density should not be compromised as this will lead to sagging over time, causing all ties to slide off eventually. To ensure functionality, I recommend a minimum infill density of 25%, although more is preferable for optimal performance. If you have a smaller printer, consider using the compact tie rack, which measures approximately 190mm in length. The standard rack, on the other hand, measures about 350mm. You can refer to this video link to learn about the design and print process: https://www.youtube.com/watch?v=P1nfMMrrbAo Thank you for your interest, and I hope you enjoy using this product. UPDATE: Note that the bracket appears bent in the provided image due to an under-sized pin; however, this issue has been resolved.