Swimbait lure type "balam" 200mm

cults3d

Hello, here is my latest creation, a swimbait inspired by the famous Madness Balam, this one with a size of 200mm will be an exeptional ally for pike fishing. -required for assembly : Piano wire Threaded insert with eyelet Epoxy glue Glue Plastic Sanding paper Lead 1- print all parts 2- sanding of the elements then deposit lead preferably in the bottom to ensure the good balance of the lure and the good maintenance of the piton of the bottom (threaded in), it is necessary to make test of leaded with each piece of the lure in order to ensure a good balance, once this validated, it is enough to stick the cover with the glue and to sand the whole once dry 3 - installation of the pitons, first screwed into the body of the lure and then ensure the proper fixation using glue, to place them at the joint, you must leave half a centimeter before the loop of the eyelet of the piton to allow the lure freedom. 4- painting and varnishing 5- molding the tail. Just print in ABS and then cast soft (you can melt an old soft lure in a glass and put it in the microwave, it works great 👍) Done bravo !!!!