Sweet stackable XT60 panel and plug mounts

prusaprinters

<p>I needed some plugs for a panel box and rather than bulky plugs, I used XT60 connectors from my R/C toys.</p> <p>You can place the XT60 male or female end as needed. I made flat panel mounts and plug housings that can stack as well. This makes a solid-feeling plug setup.</p> <p>You will need:</p> <p>Plug mount- 2 M3x10mm bolts (I used socket heads. It's what I had.) and 2 M3 locknuts</p> <p>Panel mount holder- 2 M3x10mm bolts and 2 M3 locknuts to hold the XT60</p> <p>Panel mount backing- 2 M3x10mm + your bulkhead thickness (ex. 10mm+3mm bulkhead =~15mm bolt) bolts and 2 M3 locknuts</p> <p>If you are stacking them, allow 10mm for each housing; 3 stacked fittings= 30mm bolt</p> <p>There are two plug mount files. One has arrows pointing in and one has arrows pointing out. This can be a reminder of POWER IN or SIGNAL OUT, etc.</p> <p>Have fun!</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>MakerGear</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>M2</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>.20mm layers minimum</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>20-30%</p></div> <p><strong>Notes:</strong></p> <p>2 perimeters, printed in PLA. This is going to be a close fit, so your machine should be in good tune. My XT60s fit in with no modification and stay locked in when closed.</p> <p>Prints great at .20mm and no cleanup other than maybe a light chamfer pass around the locknut holding areas with an x-acto to make it easy to insert them.</p> <p>You should not be tightening these bolts to crushing torque, just snug, OK?</p> </p></p></p> Category: Hobby