Sweeps 4Lyfe

prusaprinters

This is the result of messing around with sweeps, helixes and splines. Print with the rectangular base down, no supports. The sphere in the center already has a support(which needs to be removed post print). Overall size is about 18x18x18mm. Never seen a 24MB stl for a part less than a cubic inch before... Print instructionsCategory: Sculptures Print Settings Printer: MPMini V1 Rafts: Yes Supports: No Resolution: .0875mm Infill: 20% Notes: I used a raft, but you may not need to. There's one loop that has to build up from the build plate that might have trouble sticking. The rest are securely attached to the square base. Make sure to place the square flatly down. The sphere is already supported, so you don't need to add your own. They'd be a pain to remove anyway. Infill really only effects the central sphere.