sw9v

thingiverse

This version has been printed, and tested. originator: FMDA1776 This is a remix, with his approval sw9v tight gap, Raised honey comb grip, turns out very good if you are patient. Always a work in progress, always been functional, but constantly improving Changes from original FMDA1776 version 1. front and rear rail sections height adjusted and holes adjusted. 2. material added around perimeter to tighten gap 3. nose squared 4. take-down slot narrowed to remove slop, and have a nicer fit. (file towards the front) 5. mag stop raised to allow most aftermarket holders to fit better 6. material added here and there to allow for better hand fit/friction fit. 7. handle design added for looks and better grip, **Tab on the slide stop that engages the holder may need to be bent down slightly to account for the extra material on the perimeter, it should not need much. **And of course the factory units have a huge gap to allow for variations in machining and parts, some completion kits have turned out tighter gaps then others. Some so tight as to require slight sanding, some slightly cocked up or down. This has to do with slight differences in the slot cut in the upper for the rails, the brand of rails used, and the sear housing at the rear. May not turn out perfect on your combination straight out the oven. File slowly to a even gap. I have turned out several excellent examples, I have also trashed good prints by being in too much of hurry.