SW2 BIQU H2 V2S REVO Carriage Mount and fan duct 5015 and Bl-Touch 3.1

prusaprinters

You will find the whole project to be able to mount the BIQU H2 V2S REVO on an X2 artillery.The assembly allows to put a BL_Touch (either a TOUCH_MI, or a BL touch)The assembly is planned for a 5015 blower.For the attachment on the cover, you will need a rubber band of the same thickness as the original one.Printed in PETG in 0.16mm.If BlTouch you need aM851 X0.0000 Y25.0000 Update 11/04/2022New FanDuct and coverNew 3D renderingUpdate 11/06/2022Modification FanDuctUpdate 11/12/2022New FanDuct V3 (The previous fan duct did not ventilate well in the area, the air was scattered all over the place.)Update Cover (Reduction of the height of the cover so that the lighting is wider.Added a part to support BLtouch (antclabs 3.1 or equivalent)Increased sliding height for BLtouch (the TouchMi being by default lower than a BLtouch)Update 12/11/2022changing the positioning height of the fan duct. It was too high in relation to the nozzle.Modification of support for BlTouch (type antclabs V3.1) Added stability.Provision of Bltouch position information relative to the nozzle.Update 02/12/2023Complete redesign of the template. After testing the model for 3 weeks, I had to revise itChanged the height of the carriage, because the Vslot Wheel was touching the parts when printing and was taking them off.Modification of the insertion of the motor, more simple just by sliding itChanged the position of the PCB connectors to wire more easilyMoved the Bl-touch to the rear in a fixed position for better stabilization.Enlargement of the cover.Simplification and reinforcement of the model (the reinforcement is due to the fact that the carriage broke after 3 weeks, and that I had the Z zero that changed as I used it)Modified the height of the FanDuct and cleared the front air exhaust of the extruder.Currently the model does not support the Mi-touch (I will see later to position it correctly)In the future the model should support the BIQU MicroProbe V1.0 (if possible at the same level as the Bl-touch)Update 26/02/2023turning the bltouch upside down so that the heat is not directly on the PCBChange blower position so that the air flow is centered at the outlet. Lowering the Fanduct to 2mm above the nozzle.Update 03/06/2023Change bl touch position. it's at x 0 and Y 25.More compact modelRevised hood.Refocused air flowRevised Fan Duct to better dissipate air around the part.List of parts needed for the 3D model:Insert with Head, M3X4.8 (4 units, 2 for the fanduct, 2 for the Bltouch)  https://youtube.com/shorts/Sw0sLYyQCtw