SW-X1 Reverse Bowden M10

prusaprinters

<p>I wanted to take the spool off the top of the printer. So I made this bracket to mount to the top of the X carriage. Allowing me to put the spool of filament on a spool holder on my desk next to the printer</p> <p>This is designed to use a M5x10mm screw and a T-nut to fasten the bracket to the X-carriage</p> <p>I use a auto rewind spool holder like this one - <a href="https://www.thingiverse.com/thing:3338467">https://www.thingiverse.com/thing:3338467</a></p> <p>I used a pass thru M10 tubing connector like this one - https://www.amazon.com/dp/B01IB81IHG/ref=cm\_sw\_em\_r\_mt\_dp\_U\_7FGwDbFJG9XHA</p> <p>At this time I bypass the filament sensor by just putting a piece of filament in it.</p> <h3>Print instructions</h3><h3>Category: 3D Printer Parts Print Settings</h3> <p><strong>Printer:</strong> Sidewinder X1</p> <p><strong>Rafts:</strong> Doesn't Matter</p> <p><strong>Supports:</strong> No</p> <p><strong>Resolution:</strong> .2</p> <p><strong>Infill:</strong> 20</p> <p><strong>Filament:</strong> Amazon Basics PTEG PTEG Yellow</p>