SV06 Camera Mount MakerHawk IR Fisheye OV5647

prusaprinters

A camera mount for the “MakerHawk IR Fisheye Pi Camera OV5647” for the SV06. Designed to fit the modular mounting system arms, which can be found here: https://www.printables.com/de/model/185322-modular-mounting-system-arms-customizableMount the Camera Stepper Mount to the X stepper motor in the threaded hole on the bottom left with an M3x14 screw and a tiny washer. Attach the 80mm Camera Arm and an axis changer to it (supports required), then add the Camera Mount onto it after screwing it together with the Camera Frontplate. Finally insert your MakerHawk IR Fisheye Pi Cam into the case and screw on the Camera Backplate. I advice to put a bit of foam (cut off a little piece of the nozzle cleaning needle foam) in the backplate behind the board of the camera to make it fit more tightly. Use M3x25 screws for all of these steps. No supports required for any file but the Axis Changer.Print Speed: 50mm/sLayer Height: 0.2mmWall Line Count for each file:Camera Stepper Mount: 15 WallsCamera Mount: 22 WallsCamera Frontplate: 15 WallsCamera Backplate: 15 WallsCamera 80mm Arm: 15 WallsNo supports required Camera Axis Changer:  15 WallsSupports required on the right-hand side with the 2 arms (picture for reference), use a support blocker to disable supports on the left-hand side.I chose this amount of walls to make it more sturdy and have a solid block instead of pieces with lots of infill. Hope someone needs this if they have the same camera!