Suunto Vyper Dive Computer Bungee Boot

thingiverse

This is a Computer Boot Mount to Attach the Suunto Vyper to a Diver's Wrist via a Bungee Cord. Once printed, break off the 3 supports. For the shock cord, I used about 22.5 inches of 1/8th inch cord obtained at REI ($0.39 per foot). The holes in the model are 5mm in diameter. Tie a knot at one end and then feed the cord down through one hole, back to form an arm loop, and up through the non-diagonal back hole. Go directly across to the other back hole and down through it, forward and up through the last front hole (forming the second arm loop). Tie a second knot at that end of the cord. To tighten once on your arm, the section going across the back of the computer can be pulled over the top and held in place by the lip on the front. Change how far down the cord the final knot is tied depending on how thick of a wetsuit you are using.