Suspend game: frame rod connector

thingiverse

The connector measures 50 mm in length. Rods with diameters of 4.16 and 4.17 mm are used. A diameter of 4.16 mm was input into the model, and a multiplier of 1.05 proved successful on the first try. Printing it with the axis parallel to the print bed was chosen. Printing it upright would save support material but result in a weak outcome. Since supports are needed, minor drilling with a #19 drill bit is necessary. The resulting hole provides a tight fit with the frame rods. Holes may wear out over time, and the piece will likely need replacement eventually.