Surprising Egg (Drop Inside)

thingiverse

This is a fresh take on the classic Surprising Egg, and it's essentially just an eggshell, which you can drop your surprises inside mid-print! You can then crack it open like a real egg. I suggest using 0.8mm wall thickness (or two lines) as it's already quite tough to break (use a corner of a table or something similar to crack the egg). The egg has built-in support, which is easier to remove than slicer supports. There are four different sizes, all with 0.2mm gap between the egg and the support. Quail Egg measures 40mm Chicken Egg measures 65mm Swan Egg measures 120mm Ostrich Egg measures 190mm Check out my other designs here: https://www.thingiverse.com/Superbeasti/designs