Surfski fingergrip

thingiverse

List to glue on to the edge of your surfski cockpit to get a better grip with your hand when lifting the hull. The profile is pretty aggressive to avoid wet and cold fingers slipping, works really good even with gloves. Total length 133 mm (5.2 "). Preferably printed with no bottom layers and cubic infill. Printed this way the glue will get into the open cubes and the grip will be cemented really good. Balance the ski with one hand until level, mark the hand position and place the grip there, 5-10 mm from the edge. Mask the area with tape, sand the surface with a 360-500 grit paper and glue it in place (I use 5 min epoxy). Carefully remove the tape before the glue sets to get a clean edge.