Surfacemount Case for "Danfoss Link"

thingiverse

This is a special installation kit for a "Danfoss-Link" heating controller. The power supply unit should be mounted inside a flush-mounted box within the wall. As this was not possible here, I fabricated a custom box to secure the controller to the wall. Please study the instructions carefully since this design may have imperfections. Instructions There are two models available for use: width- and support-less. The distinction lies in the upper mounting holes; they were difficult to obtain without assistance, so I produced a thin support plate beneath the holes to rectify the situation. This is the version known as "with-support". For those preferring traditional support beams, the model called "without support" should be selected. Assembly and Installation Screw four M4 nuts into the upper holes first. Inserting the bolt alone, without the controller, allows for easier nut installation; draw it in fully to ensure secure anchorage, then remove the bolt.