SureFire flash hider

thingiverse

##Annotation SureFire flash hider for airsoft guns. Threading is M14x1 CCW. ##Instructions Print best in ABS with 0.3 mm nozzle, 0.15 mm layer width for most smoothness and detail. You may print using 0.4 mm nozzle, with 0.2 mm layer for strength. If it sticks or too tight you may use silicone lube or heat inner thread with a lighter or heater. And remember to clean/scrape threading thoroughly after printing. # Russian Annotation SureFire flash hider for airsoft guns. Threading is M14x1 CCW. ## Russian Instructions Print best in ABS, nozzle 0.3 mm, layer 0.15 mm if details are important. For strength you can print with nozzle 0.4mm, layer 0.2 mm. If too hard to screw on use silicone lube or heat inner thread with lighter or heater. And remember to clean/scrape threading thoroughly after printing.