Supporto Smartphone Sony Xperia Z1 Compact

thingiverse

I have numerous coils of wire that were quite disorganized, with loose wire ends that were either taped down or tucked into the wire. A plastic clip to hold it in place would be a better option - as you can see below. The coils I am using are usually available from Fry's, Micro Center. They typically measure 50mm in diameter when fully loaded and decrease to around 30 mm when empty. To accommodate different reel sizes, I created two variations for each of two reel heights, one for a mostly full spool and one for a mostly empty spool. However, I didn't have access to a mostly empty spool, which meant I couldn't test the 30mm size - although it's hard to imagine why this wouldn't work. Print Settings Printer Makerbot Rafts: It Doesn't Matter Supports: It Doesn't Matter Resolution: 0.2 Infill: 10% Notes: Nothing out of the ordinary occurred during the print process. I used a glue stick to attach the print to the bed, which was enough to prevent it from lifting off - no rafts or support were required.