SUPPORT SUCH, CREMAILLERE SUPPORT SUCH

cults3d

Good morning, here is a rather specific sharing, in fact the probabilities for someone to have this type of support are rather thin... But I still post, you never know. If you have this model I'm sure the part in question has failed. It is a support for such "Rugged" or "hardened" about 200g or more... In my work I have a model of such of equivalent building site and as it weighs the weight of a brick consequently at the end of a time the sole, more precisely the "rack of suction cup", did not hold ! Makes sense. Too bad for this so practical support, it bothered me to benner it. After a rough measurement I started modelling this piece a little complicated for me, but good... After a while it makes a truk quite similar to the original (black piece on the picture where you can see that it has no octagonal base) And hop to the printer... Because of the "way, way" dimensions it's a bit steep but it works, I think it will be done after 2/3 manipulations. In terms of rendering the piece is very ugly, I don't know why? Maybe the fact that it's small enough, too small for the printer? Too many details, I don't know... In any case it works!!! The supports were very difficult to remove, again probably because of the size of the part... Or the setting of the contact area with the model? Come on, a little patience and scratching and it does it for a second life to this support:) Enjoy!