Support ruban LED (CR10 U20 U30 sans vis - without screw) + Switch ON/OFF

thingiverse

Here are supports for LED ribbons to place on the top of the structure and/or on the rail of the nozzle carriage. *** PLEASE READ: Position the elements in your slicer as shown in the picture provided (vertically except for the switch case). They should not be printed flat, or the efficiency of the clips may be reduced, or the clips may be rendered inoperable! *** Be careful to use LED ribbons 8mm wide. These STLs are made to be fixed on horizontal rails only - top of the structure and/or rail of the nozzle carriage. **1)** Two supports are provided: one is 30 cm (top of the structure) and the other is 25 cm (profile with the nozzle carriage). For vertical profiles, you can simply slide the 8mm LED strips into the profile on the height. Do not place these supports that I provide on the height. **2)** A box is provided to insert an on/off switch connected to the cables. It closes like the rails and does not require any tools. [Link to the on/off switch KCD1-104](https://french.alibaba.com/product-detail/21x15mmfull-black-four-legs-dpst-kcd1-104-rocker-switches-60795238662.html) **3)** Cable covers are provided to hold the cables. They are also clipped without tools. How ========== To clip the modules, tilt the piece to fit into the rail the notch provided for this purpose. Lower it while pressing firmly until you hear the clip. All modules use this technique. For power, I used a simple 12V 1.5 amp transformer. Feel free to contact me for more information :-)