support roues porte de douche

thingiverse

Bonjour, It's my first upload, so don't blame me too much... The original piece was made with Tinkercad and here is the link: https://www.tinkercad.com/things/hJHgbGX4Sn9 There are two pieces, one with an 8mm hole and the other with a 9mm hole (named with underscores between each word) If this can help someone when their piece breaks on a Sunday before taking a shower My settings: I made a first draft in PLA (purple translucent low-cost) at 185°C and bed at 60, filling at 20% (5 would have been enough) The final piece in ABS, bed at 110°C and hotend at 230°C, SUNLU transparent filament, filling at 100% No supports on both pieces, raft on both pieces Hotend 0.4 layer height for the draft and finale at 0.1 Wall thickness and top/bottom 1.4mm Wall lines 3 Upper and lower layers 7 Draft speed at 100mm/s and finale at 60mm/s Filament 1.75mm