Support Relay 1 channel (Type ZXHPCB) Arduino

thingiverse

Here is a simple upright relay model used with Arduino. It was created to address the need for fixing it in one place, and the model lacks holes to utilize spacers. I chose ABS, printing at 30% without support. To achieve a better finish and fit, use sandpaper. Printing speed should be set at 70mm/s; however, slower speeds can also be used if necessary. The side holes are designed for passing small wires and extending the status identification LEDs. https://pt.aliexpress.com/item/5V-Low-Level-Trigger-One-1-Channel-Relay-Module-DC-AC-220V-Interface-Relay-Board-Shield/32801667044.html?spm=a2g03.search0104.3.15.AaHlUH&ws_ab_test=searchweb0_0,searchweb201602_3_10152_10151_10065_10344_10068_10342_5790020_10547_10343_51102_10340_10548_10341_10084_10083_10307_5060020_5130020_10312_10313_10059_10314_10534_5000020_100031_10604_10103_10605_10594_10142,searchweb201603_2,ppcSwitch_5&algo_expid=3fca0a56-9ef8-4e2f-af5e-93c4120d9fe6-2&algo_pvid=3fca0a56-9ef8-4e2f-af5e-93c4120d9fe6&rmStoreLevelAB=5