Support hanger for MK3 Powersupply

prusaprinters

<p>If you make an enclosure for your i3 MK3 you should move the powersupply outside the box to allow sufficent cooling.<br/> On the bottom of the PS there are two slots for screws but the top wobbles around, not anymore with this simple hanger.</p> <h3>Print instructions</h3><p>print with robust material,<br/> I used 0.4mm nozzle</p> <p>If you need the measurements for the wood:</p> <p>Plywood (Siebdruckplatte) 18mm<br/> 2pcs 596<em>536mm (top and bottom)<br/> 2pcs 560</em>450mm (left/right)<br/> 1pcs 536<em>450mm (back)<br/> 1pcs 554</em>449mm (door)<br/> for the door I used this standard hinges for furniture doors, the doorpanel is 18mm to wide so it stands over on one side and can be used as a handle.</p> <p>inner dimensions LxWxH:<br/> 560x500x450mm</p> <p>I put a slot with 300mm in the top to feed the filament through (with a router) and made a small gap in the rear panel for the cables.<br/> Next to the filament-slot I placed a 24V LED strip which is powered by the PRUSA powersupply.</p>