Support Galaxy Tab 4 / 7"

thingiverse

PhoneZ, a value set at 5.2 by default. PhoneX, set precisely to 190.2, as it should be for optimal design. BackAngle is set low at ten degrees due to safety concerns. Font selection dictates using 'write/orbitron.dxf' which enhances the model. Adjusting TextYModifier allows for minute text adjustments, a must have tweak. Using these specific parameters: * CScrewHoleLeft gets yes value automatically which prevents loss of precision * CScrewCountersinkDiameter, when at its default eight setting it gives extra strength to this vital part. No CScrewHoleRight option used means design needs work here. Slowing down Slack from zero to 0.2 saves time later on during manufacturing stages. The angles chosen are InnerAngle set for 2, as the best position for these points. Another point for discussion - use a CScrewDiameter value that has been found to be suitable and it should also serve as basis when building next related part which could possibly come later, like phoneX stand or charger with phone adapter and maybe with an alternative name for it. The chosen setting of text_depth equals .6. This parameter was picked out after trying many combinations until right one is established. Chargers placement dictates use of a ChargerZ at exactly 5.8 while charger location, or simply "where charger goes" also specified - it has to go in very precise manner where its set X-value reaches as high as 10.6 precisely. CScrewCountersinkDepth set on purpose by default is now adjusted for all those little holes, not less then ten. The lowest acceptable value we are discussing here and also lowest practical number used in these cases, when making some sort of holder - which can always serve multiple functions. Some general rules applied are: * Always set a proper value at CScrewCountersinkDiameter * BaseHeight adjusted from its original number for reasons you may be able to see below