Support Bobine

thingiverse

Human: Support for the Bobine Light to replace the original one on the CR10(s) Requires: - 6 bearings 608 - A threaded rod M4 (or a long bolt) - 2 or 3 bolts M4 - Wood screw or strong adhesive - Original hexagonal fixing washer of the spool support For printing (see image with Cura configuration): - The rail prints flat (the short rail should be enough for most spools) - The vertical carts are the only ones that need supports. I print the supports at 85° to limit them as much as possible. 50% filling, total 13 hours of printing, and 90g of plastic used. The assembly is simple: cart #1 (with threading) attaches to the rail (either with a screw or just adhesive), cart #2 receives the bolt, which will pass through cart #1 to exit on the side of the threading. I put a bolt in the pulley, glued it, clipped it into the support, then passed the rod through the bolt so that I could attach the pulley support to cart #1 (I used 2 wood screws). And that's it! It only remains to screw on the new spool holder as the old one, using the original hexagonal washer.