Support batterie externe PiGRRL 2

thingiverse

Makes it possible to position the Lithium Ion Polymer Battery - 3.7v 2500mAh outside of the enclosure to prevent parasites and improve system cooling (not tested with a 2000mAh battery but being normally smaller it should fit without issues). 4 freshened non-mechanical heads 4mm x 20mm. 4 screws diameter 4 mm. 4 washers diameter 4 mm. Double-sided for maintaining micro switches. -Position the enclosure without the cover facing the holes of the PiGRRL2 and stick the switches, ideally at the center of the button housing. -Take the enclosure in hand aim at the 4 screws in the cover and in it. -Insert the battery into the enclosure without forgetting to pass the wire through the hole. -Squeeze all together and aim at the screws inside the PiGRRL2 without tightening too much. It's entirely possible to install the enclosure on a non-modified PiGRRL2, you just need to drill and adjust the holes to allow wire passage and also file down the two screw supports from the top (those allowing the switch plate attachment). (New ergonomic buttons) Printer Settings Printer Brand: RepRap Printer: DAGOMA Disco 200 Rafts: Doesn't Matter Supports: Yes Resolution: 0.2