SuperFly remixed (again)

thingiverse

This is a remix of NikNakTak's excellent remix of MustCode's very cool SuperFly extruder. I loved how compact MustCode's design was, but the tolerances were very very hard to work with, and NikNakTak relaxed a lot of the tolerances and redid the idler gear carrier to a more conventional design. NikNakTak's remix was based on the parts from his Sapphire BMG clone, which has a 29mm main drive shaft, compared to the 28mm shaft on the original BMG and close clones. I've modified the Main_housing_MrMaooo by padding the main housing by .2mm and then adding an extra .5mm lip to the bearing carrier. This positions the main shaft well for my original BMG, as well as a Fysetc clone I had laying around, while also supporting the end of the shaft closest to the stepper. I have also added a Bearing_carrier_raised1mm which extends the raised lip a full 1mm. This bearing carrier allows the shaft to be supported on the stepper side when used with the original housing. However there is more freedom for the shaft to slide around and it may take some more wiggling to get the groove for the filament to line up properly with the housing's filament path. The last change was to put a cutout in the tensioner arm so that a 3mm t-nut could be used to hold the thumbscrew in place. I don't have any of the thermal inserts handy, and I had a lot of t-nuts around, it isn't as good, but some people may find it handy. I'll probably include a version that takes a 3mm nut as well soon