Superba Tension Mast Cap

cults3d

This design duplicates the left and right end caps required to secure the discs and springs on the Superba 1602 tension unit. When printed with PLA, the tabs that secure the caps to the cover are thin but strong and flexible. Very little force is required to snap the cap into place. The cap is a tight fit. It's easiest if you follow these steps to install: 1) Align the center socket of the cap with the small brake spring. 2) Align the center pin on the cap with the hollow in the two braking discs. 3) Push on the cap to compress the two springs and position the center socket on the tension unit shaft. 4) Gentle press inward on the two tabs and insert them half-way into their corresponding holes. 5) Push on the cap above the springs until it securely snaps into place.