Super Dungeon Explorer Token Dispenser

thingiverse

Super Dungeon Explorer board game uses lots of these little cardboard coin-shaped tokens, so I built a holder for 18 sets of them. Also included is the Sketchup file and component so you can tweak or remix. Print Settings: Printer: Zortrax M200 Rafts: Yes Supports: No Resolution: .19mm Infill: Full Notes: The uprights broke consistently while printing on my old un-lamented Solidoodle SD4, so I set infill to "Full", which is the maximum, (though not 100%), to make it stronger. This resulted in an 11-hour print, so I'd probably back off on the infill to speed thing up if I were to print it again. Also, it's a little more snug on the Zortrax printer, but still works fine. Maybe open up the Hole offset (or print the whole thing a little bigger). You probably want to print the component and check for fit before firing off the big piece.