Sunlu S1 Top Mount Creality Ender 3 S1

thingiverse

My Approach for a top mount for the Sunlu Filadryer S1 on the Creality Ender 3 S1. Since this printer is so new there are not a lot of customizations yet so I did it myself. The top Mount for the original Ender 3 would not quite do the job because on the Ender 3 S1 there are 2 Y-Motors with guides on top wich wouldn't fit with the mount at both sides. Additionally there is the new holder for the filament rolls wich has a filament runout sensor attached that needs to be located in a certain portion of the printer top because the cables are oriented that way. Essentially what it takes is just the original 20x20 Mount for the middle and the remix for the left side of the printer top. From my experience it sits quite sterdy on top and there is no need to make use of any mounting hardware such as screws because there is no obvious opportunitys for them on the Ender 3 S1 unfortunately. The design of this printer is very refined and there isn't a lot of good options for mounting at all because everything is covered with nice surfaces.