Sunlu FilaDryer S1 Mount for V400

thingiverse

The default filament spool with the v400 is mostly okay but can be better. I already had a Sunlu S1 FilaDryer that I've had good results with, so I wanted to mount it to the top of the printer to act as the spool holder. Unfortunately, as the rear pillar of the V400 is up against the wall, there wasn't a way to mount it straight on the top of the V400 with any existing mounts. After finding Henna's great wall mount for the FilaDryer, I added two screw holes angled as I need it, but still providing enough support to keep the FilaDryer in place on top of the unit and be powered in. Note: The screw holes are slightly oversized for the spoolholder's M3 screws. This is intentional to give you enough space to change the angle slightly if needed before tightening them down. Once I tightened them down there is no give to the unit.