Sunhokey Prusa i3 Adjustable Dual Fan Duct

pinshape

This is a custom Fan duct designed for direct mounting on the original Fan location. My printer, a Reprap Prusa Sunhokey 2015 model, had an upgraded extruder, which was slightly shorter than the original one. I needed a dual fan duct that would precisely direct air flow exactly where it's needed. This Bracket and duct assembly is adjustable in all three axes. The bracket is securely attached to the frame and can be shifted along the x-axis. The ducts are adjustable in both y and z axes, allowing for precise control of air flow direction. Standard 40mm 12V laptop fans were used, which require two fans wired in parallel. After installing them, I wrapped the fan ducts with foil tape to prevent sticking to the extruder in case of a jam. Printer Details * Brand: Prusa * Printer Model: Prusa Clone * Rafts: Not Used * Supports: Not Used * Resolution: 0.2-0.3mm * Infill: 25% * Notes: Printing with supports is not recommended as it's difficult to remove them after printing.