Sunglasses Car Sun Visor Clip V2

prusaprinters

ThingiverseThis is a design I transferred over from Thingiverse.  OverviewAn updated version of my original sunglasses car clip. This version is designed to hold some glasses better, as well as being designed to be less prone to bending because of heat like the previous version was.  Print RecommendationsFor hot climates, PLA will likely melt a bit and cause the model to bend. Comments typically recommend Nylon or ABS (thank you, everybody). I also would recommend using a higher percentage infill so that there is more plastic if it does soften.Layer Height: 0.15-0.2mm QualityMaterial: Depends on your climate, Nylon, ABS, or PETGInfill: 30% or higherSupports: NoneV1Also included is a link to V1 in case you prefer that design or want to read the tips in the comments. Printables Link to V1 or Thingiverse Link to V1Category: Organization