SUNFIRE 2 ALTERNATE PULLEY VERSION 2

thingiverse

ALTERNATE PULLEYS FOR THE SUNFIRE 2 CONE WINDER. THESE REPLACE VARIOUS PARTS. PETG OR ABS ONLY. IF MADE WITH ANY OTHER MATERIALS THAT WILL BE CONSIDERED A DERIVATIVE. PRINTING NOTES INVERT THE SMALL CONE DRIVE PULLEY FOR PRINTING PRINT ALL PARTS AT SAME TIME USING ONE ROLL OF FILAMENT. 2 LARGE PULLEYS AND ONE EACH OF THE OTHERS. DO NOT MIX WITH PARTS MADE AT DIFFERENT TIMES OR MIX WITH PARTS FROM ORIGINAL POST. A PAUSE IS REQUIRED TO INSERT 6-32 HEX NUTS IN THREE OF THE FOUR PARTS TO BE PRINTED AT SAME TIME. THE OVERHANGS ARE SEVERE BUT IT IS POSSIBLE TO PRINT WITHOUT SUPPORTS. IF YOU NEED SUPPORT USE THE ORIGINAL VERSION PULLEYS. PERIMETERS 3 UOS LAYER HEIGHT .2 UOS BOTTOM 3 LAYERS TOP 3 LAYERS INFILL 30% RECT HEIGHT 5.5-9.8mm .1 LAYER HEIGHT FOR SMALL SCREW DRIVE AND LARGE PULLEYS 9.8-26mm 100%PERIMETERS