Subaru Impreza 2008-2011 Cup holder adapter

thingiverse

Tired of spilling your beer while cruising around in your Subaru Impreza? This invention is for you!! Seriously, I always end up spilling anything I put in my Impreza cup holder because it's too big to fit normal soda cans so they keep swinging around when I drive. I came up with these little rings to make them fit perfectly. In my car, the front hole was a bit bigger than the rear one, so I made it 0.5mm larger. I'm not sure if that's true for everyone. This should fit any Impreza from 2008 to 2011 Sedan (2.5i and WRX), but I'm not sure about STi models; tell me if you ever try it out! It might fit many Subaru cars between these years, but I'm not sure about other models - let me know if you give it a shot. Enjoy! Print Settings: Printer Brand: RepRap Printer: PRUSA I3 X Rafts: No Supports: No Resolution: 0.3mm nozzle 0.3mm layer Infill: 20% Notes: I printed them flat in an heated bed with PLA, so a 90-degree rotation on the X axis is required in the slicer. Do not use PLA - tested it on a hot summer day and it shrank! I'm going to remake them in ABS and get back with the results.