Sturdy Quest 2 Headphones w/ Swing for Orzero

thingiverse

Edit: The mount is a better solution that puts the mount more to the rear of the headband and on the plastic rear headstrap, It is a mount as its not a clip and requires threading the headband through a hole in the mount for better rigidity. I ordered an Orzero style head strap for my quest 2 and saw that the possible mounting area for the clips of the Koss headphone mount is probably too small to slide for adjustment, but I also wanted the rigidity of the sturdy headphones remix, so I came up with a solution using way more hardware than necessary. Hardware needed: 2x M5x12mm Socket Cap screws 4x M5 Fender Washers (15mm in diameter, 1mm thick) 2x M5 Washers (10mm in diameter, 1mm thick) 2x M5 Nuts (3mm thick) 2x M5x20mm screws !!! Plus all the hardware from the original STURDY headphone mount! !!! Each clip gets 2 fender washers on either side, both pins gets a nut inserted from the top and a washer inserted from a hole in the bottom of the print. The M5 screw goes on the inside of the clip and screws into the pin. Adjust tightness of the M5 screw to adjust resistance of the swing.