Sturdy Accessory Holder for Dyson V6 V7 V8

thingiverse

Sturdy Accessory Holder for Dyson V6, V7, and V8 Vacuums This accessory holder is designed to work with the big motorized vacuum heads. It holds accessories securely in place, just like the factory dual accessory holder built into the charging station. Simply snap your accessories from underneath and release them easily. The intended mounting position is flat side up, with two side mounting holes above a single center mounting hole. This design allows for easy installation on walls using good wall anchors. This accessory holder was designed to be friendly to FDM printers: * Custom supports are integrated for holes, which snap out with minor cleanup - no slicer supports needed. * Big overhangs are less than 20 degrees off vertical. * Only a few small chamfers result in a few layers of 45-degree overhangs. * A large surface touches the bed for better bed adhesion. This design was inspired by Cornick's Dyson Attachment Storage, but it didn't fit my attachments. I've flagged this as a remix to show respect for the original creator.