Stubby HW-384 USB Case

thingiverse

I have remixed the XT60 USB Charger design to be shorter and to accommodate a cable coming out of the case.I usually use the HW-384 USB board with Wagos to connect it to my power source, although this remix allows any 6-24VDC connector/cable to be used.I have also added holes on both sides of the case at the back to allow a small cable tie to be used as strain relief for the connecting cable.Also tightened up the tolerances of where the board sits inside the case so now the HW-384 board does not move when a USB cable is plugged in and unplugged.You will need 4 x M3x10mm to screw the two pieces together, at least this is what I used, I don't know what the original designer intended.Edit: I edited Part 1 to include the input voltages, output voltages and output amperage debossed on to the outside of the print.