"Stubbin' " Vertical Stubby Foregrip

prusaprinters

<p>A basic stubby foregrip that attaches to a 5+ slotted section of picatinny rail. Two versions&nbsp;<br>of the design are available; Standard (Smooth Grip) &amp; Rib'd (Fo yo pleasure, baby)</p><p>Remember, it may be a stubby, but it has so much potential. :P<br>(Insert cringe here.)</p><p>&nbsp;</p><p>Hardware Needed:</p><p>1x M5x30 Hex Socketed Machine Screw/Bolt</p><p>1x M5 Hex Nut (Be sure both bolt &amp; nut are the same thread pitch.)</p><p><br>Installation:</p><p>1) Press the M5 hex nut into it's indexing socket.</p><p>2) With the hex nut installed, slide the forgrip onto the rail and align the bolt channel with<br>&nbsp; &nbsp; &nbsp;the preferred rail slot of installation.</p><p>3) Drive the bolt through the channel and start threading into the hex nut.</p><p>4) Tighten the bolt into the hex nut until the foregrip is mounted firmly in place. The end of&nbsp;<br>&nbsp; &nbsp; &nbsp;bolt shouldn't protrude past the hex nut indexing slot. Avoid overtightening the bolt.&nbsp;</p><p>&nbsp;</p><h3>Print instructions</h3><p>Print Settings:</p><p>Extruder: 204C&nbsp;<br>Bed: 56C&nbsp;<br>First Layer Print Height: .20mm&nbsp;<br>Standard Layer Height: .14mm<br>Wall Thickness: .40&nbsp;<br>Wall Perimeters: 3 - 4<br>Infill: 25%<br>Infill Pattern: Gyroid<br>Material Flow: 100%<br>&nbsp;</p><p>Print from the bottom of the grip, no support material is needed.</p>