Structure Sensor - 3D Scanner case adapter for iPhone 7

thingiverse

This is a case designed to fit an Occipital Structure Sensor, 3D scanner onto an iPhone7. The case was created from scratch based on Apple's specifications, matching the phone's curve and corner rounding exactly. To accommodate the Structure Sensor, I extended the back of the case. The bottom right corner has been intentionally left unsupported to allow for some movement when fitting it to the phone. For printing purposes, I've included anti-warp discs that can be easily snapped off. Any sharp points should be smoothed out with a lighter. Warping will prevent the phone from fitting properly, so make sure to avoid this. After printing, clean up any residue or blobs from inside the curve. These imperfections will also hinder the phone's fit. I printed this case at 0.2mm layer thickness and used infill percentages ranging from 20-100%. Please note that this design is for personal use only; it may not be commercially distributed without permission.