Stronger Z End Stop Mount for Folger i3 2020 8mm bar

thingiverse

The end stop mount that comes with the Folger i3 2020 has a major flaw. It doesn't sit perfectly still: when trying for precise alignment, even a slight movement is unacceptable. The limit switch mounting holes are positioned far too close to the middle of the plastic - ideally they should be right on the edge so the carriage always triggers the switch before it collides with the mount. Animoose recognized this issue and modified the design to resolve it at http://www.thingiverse.com/thing:954149. This upgraded end stop mount solves both problems by relocating the holes a good 2mm outward, as well as increasing the clamp area for better hold on the 8mm rod. The new setup won't give in an inch! It utilizes M3 screws and a single M3 nut. Print Settings Rafts: None Supports: None