Strong and light mini fpv racer quadcopter

thingiverse

UPDATE : multicopter4 : Extremely Lightweight and Virtually Unbreakable : 8-9 grams for the frame 39 grams with motor, propeller, camera, and board. You can use a 500mAh or 600mAh Eachine Lipo 1S. This quad was designed using my custom nodal editor GRAPHSCAD : http://graphscad.blogspot.com Added an OpenSCAD file. This drone is fully customizable. You can choose the size of motors, base plate, propeller size, etc...... Added propeller protection as well. Have Fun! This drone is incredibly small and extremely light (print it with 0% infill). The strong structure can handle even the hardest crashes. Printed with 1.75mm PLA (2800mm of wire, you can calculate the weight...). 0.2mm resolution, 0.2mm per layer. Really flies like a beast (much better than my QX90) with a F3 brushed board. Using Betaflight 3. The center of gravity is really good, rolls and flips are amazing. Using 55mm blades and ChaoLi 8.5x20 motors. 500mAh or 600mAh Lipo 1S Eachine. Most brushed boards can fit. 6 minutes of flight in Accro mode. Camera antenna is protected because it's located under the motors and props. Motor holders are efficient. Just clip the motor inside until it's locked. The bottom part clips into the top part. Depending on your printer, you'll have to enlarge manually clip holes until you can clip in force. No glue needed. Try it! I've printed a lot of mini quads, and this one is the best ever. Print Settings: Printer: Prusa i3 remix Rafts: No Supports: No Resolution: 0.2mm Infill: 0% Notes: Print it with 0% infill. It's strong and light.